Masterfully crafted in Toronto, this lube is a remix of Hugo's Thick Lube V1. We've been able to get this product industrially made and tested to have the same SDS properties as Krytox 205g0. Comprised of the same base PTFE and PFPE but at a much lower cost. Direction: Whip gently before use. Apply to affected areas carefully using a fine brush. Remove excess as required. Keep away from pets and dust.
Krytox™ GPL 106 is high viscosity lubricating oil. Its ideally used as spring lube but has seen application on linear switches too. Its high viscosity allows it to stay adhered to springs without flowing off and pooling to the bottom of the switch housing.
Krytox™ GPL 105 medium viscosity lubricating oil. Its ideally used as spring lube but has seen application on linear switches too. Its viscosity allows it to be applied quickly and efficiently onto springs. Its also viscous enough to adhere to springs when applied in a thin enough coat.
Oils, when applied properly, can help reduce spring ping/spring crunch noises.
Each bottle approximately 5ml.
Please note that all lubricant purchases are non-returnable & non-refundable once the sale is final.
Please note that this ais a industrial product. Keyspresso is not responsible for any damages from inexperienced usage. Please do not ingest or leave on skin.
Great for lubricating stabilizers. Not recommended for switches.
From the manufacturer:
XHT-BDZ is the highest viscosity grease in the XHT-BD Series. Krytox XHT-BD greases are designed for use where the temperatures are in the 288 °C (500 °F) range and higher, where there is a danger of melting the standard PTFE thickener. This grease uses a special non-melting high temperature thickener. The base oil is an extremely viscous oil that provides good viscosity and lower evaporation at high temperatures. Krytox XHT-BD greases are for use in low speed bearings or in pillow housings and will shear at high speeds, causing loss of oil in sealed bearings. The oil in the grease can begin to slowly evaporate at temperatures above 330 °C (626 °F), and this will occur at an increasing rate as temperatures increase. Re-lubrication could be required at these temperatures to achieve optimum life.
These premium brushes are made for long-term use and won’t fall apart halfway through a lube job. The grip is specially designed for comfort and the thin tips allow for precise and even lube application on switch parts.
As a best practice, we recommend using a separate brush for each type of lube to avoid mixing and contamination.
Round brushes are great for beginners and those who want very fine control over lubing.
Flat brushes are great for those who have great hand control and want the ability to apply more coverage with less work for specific surfaces.